Aircraft noise in Mitchell, SD

Mitchell, South Dakota is one of the quieter places for aircraft noise: it scores 1 out of 10 (Minimal) on the NoiseAbove Score. Loud overflights (louder than 60 dBA outdoors, about a loud conversation) were rare: less than one a month over the past year. The nearest airport is Mitchell Muni (MHE), 3.3 miles to the north. Flight-tracking coverage of low aircraft is thin here, so the real figure may be higher.

1
Minimal aircraft noiseLow confidence. Receivers rarely see low aircraft here: low helicopters, crop dusters and military flights may be missed.
0loud overflights a day (60+ dBA)
0very loud a day (70+ dBA)
0loud overflights a night (10 pm–7 am)
under 25 dBday-night average level (DNL)
under 25 dBnight average level
62%of South Dakota towns are louder

Open Mitchell on the noise map or search a street address there for a closer reading.

What makes the noise

Too little aircraft noise reaches the ground here to break down by aircraft type.

How Mitchell compares

Mitchell is quieter than 62% of the 74 South Dakota towns we cover. The typical (median) score for South Dakota towns is 1. See all South Dakota towns.

Airports nearby

AirportDistanceDirection
Mitchell Muni (MHE)3.3 miles (5.3 km)north
Parkston Muni (8V3)24 miles (38.9 km)south

Military flying

No military airfield within 15 miles (25 km), no low military operations areas overhead and no military training routes nearby.

Nearby towns

TownScoreDistance
Parkston, SD123 miles
Salem, SD133 miles
Freeman, SD140 miles
Huron, SD144 miles
Wagner, SD146 miles
Platte, SD146 miles
Madison, SD250 miles
Parker, SD251 miles

About these numbers

Estimates for the center of Mitchell (population 15,621, 2023 Census estimate), from flight tracks recorded on every third day between November 13, 2025 and November 11, 2026 (120 days) and a noise model. They are not microphone measurements. Noise can differ a lot within a town, especially near a runway, heliport or flight path, so check your street on the map. Read how the score works and its limits. Not for regulatory, legal or lending decisions.