Aircraft noise in Edgewood, NM

Edgewood, New Mexico is one of the quieter places for aircraft noise: it scores 1 out of 10 (Minimal) on the NoiseAbove Score. Loud overflights (louder than 60 dBA outdoors, about a loud conversation) were occasional: about 3 a month over the past year. The nearest airport is Sandia Airpark Estates East (1N1), 4.0 miles to the southeast.

1
Minimal aircraft noiseMedium confidence. Receivers see some low aircraft here, but may miss part of them.
0.1loud overflights a day (60+ dBA)
0very loud a day (70+ dBA)
0loud overflights a night (10 pm–7 am)
under 25 dBday-night average level (DNL)
under 25 dBnight average level
62%of New Mexico towns are louder

Open Edgewood on the noise map or search a street address there for a closer reading.

What makes the noise

Too little aircraft noise reaches the ground here to break down by aircraft type.

How Edgewood compares

Edgewood is quieter than 62% of the 140 New Mexico towns we cover. The typical (median) score for New Mexico towns is 1. See all New Mexico towns.

Airports nearby

AirportDistanceDirection
Sandia Airpark Estates East (1N1)4.0 miles (6.5 km)southeast
Moriarty Muni (0E0)16 miles (26.3 km)southeast
Albuquerque Intl Sunport (ABQ)23 miles (36.8 km)west

Military flying

No military airfield within 15 miles (25 km), no low military operations areas overhead and no military training routes nearby.

Nearby towns

TownScoreDistance
Sandia Knolls, NM14.8 miles
Ponderosa Pine, NM613 miles
Moriarty, NM113 miles
Carnuel, NM414 miles
Sandia Heights, NM215 miles
Placitas, NM218 miles
McIntosh, NM120 miles
Bernalillo, NM423 miles

About these numbers

Estimates for the center of Edgewood (population 6,130, 2023 Census estimate), from flight tracks recorded on every third day between November 13, 2025 and November 11, 2026 (120 days) and a noise model. They are not microphone measurements. Noise can differ a lot within a town, especially near a runway, heliport or flight path, so check your street on the map. Read how the score works and its limits. Not for regulatory, legal or lending decisions.